Liner type has no impact on bone mineral density changes around a 3D printed trabecular titanium acetabular component - 01/02/23
, Ali Bayan a, Ian Holdaway d, William J. Farrington a
Bienvenido a EM-consulte, la referencia de los profesionales de la salud.
Artículo gratuito.
Conéctese para beneficiarse!
Abstract |
Background |
Three-dimensional printing of implants allows the ability to produce implants and interfaces which theoretically better mimic “normal” bone behaviour, leading to a possible reduction in stress shielding thus maintaining bone mineral density (BMD). This issue was not investigated in vivo using bone scan and different bearings; therefore, we did a prospective study aiming to answer: 1) is there a loss of BMD around the 3D printed trabecular titanium cup, when compared to the native hip?; 2) does liner type influence the BMD changes around the acetabulum when a 3D printed trabecular titanium cup is used?
Hypothesis |
BMD changes around the acetabulum are not influenced by the liner type, and the cup will be associated with a reduction in BMD when compared to the native hip.
Material and methods |
This is a prospective observational study of patients receiving a primary total hip arthroplasty. A 3D printed trabecular titanium uncemented acetabular component was used in all cases. All patients received a ceramic femoral head, with either a ceramic or polyethylene acetabular liner. BMD measurements using DXA were performed at 6 weeks, 6, 12 and 24 months after surgery to evaluate remodeling changes. The 3 acetabular regions of interest (ROI) of DeLee and Charnley were used for serial comparisons of peri-acetabular BMD. The study was powered as a non-inferiority study with the principle variables compared using a two-step repeated analysis of variance.
Results |
A total of 48 consecutive patients were included in the study, with all patients completing their 2 year follow-up. There were no failures, revisions or complications within this cohort. We found no statistically significant difference in the BMD change scores between the operated and the native hip in any of the 3 ROI zones. We found no differences in BMD scores when comparing ceramic to polyethylene acetabular liners, head sizes and BMI.
Discussion |
This study shows a similar pattern of BMD behaviour around a 3D printed cup when compared to the contralateral native hip. We were unable to show a clinical or radiological difference between the bearing material, head size, or BMI when used with this type of acetabular component.
Level of evidence |
III; prospective comparative study.
El texto completo de este artículo está disponible en PDF.Keywords : Total hip arthroplasty, Cementless, 3D printing, DXA, Bone density
Esquema
Vol 109 - N° 1
Artículo 103136- février 2023 Regresar al número
Artículo precedente
- Wear rate and osteolysis in two types of second-generation annealed highly cross-linked polyethylene in total hip arthroplasty: A retrospective comparative study with a minimum of five years
- Naoki Yamamoto, Ryohei Takada, Tetsuya Jinno, Kazumasa Miyatake, Naoto Watanabe, Hideyuki Koga, Toshitaka Yoshii, Kazuyoshi Yagishita, Atsushi Okawa
- Doctor, what does my ceramic-on-ceramic hip arthroplasty weigh?
- Simon Marmor, Emmanuel De Panafieu, Antoine Mouton, Wilfrid Graff, Vincent Le Strat, Luc Lhotellier, Younes Kerroumi, Emmanuel Gibon
Bienvenido a EM-consulte, la referencia de los profesionales de la salud.