Finite element analysis of different titanium miniplates: Evaluation of three-dimensional designs applied on condylar neck fractures - 11/07/21

Doi : 10.1016/j.jormas.2021.06.011

Paris Liokatis ^a,^⁎ , Georgios Tzortzinis ^b, Simos Gerasimidis ^c, Wenko Smolka ^d
^a Department of Oral & Maxillofacial Surgery, Ludwig-Maximilians-University of Munich, Germany
^b Department of Civil and Environmental Engineering, University of Massachusetts, Amherst, MA, USA
^c Department of Civil and Environmental Engineering, University of Massachusetts, Amherst, MA, USA
^d Department of Oral & Maxillofacial Surgery, Ludwig-Maximilians-University of Munich, Germany

^⁎Corresponding author: Department of Oral & Maxillofacial Surgery, Ludwig-Maximilians-University of Munich, Lindwurmstr. 2a, D-80337 Munich, Germany.Department of Oral & Maxillofacial SurgeryLudwig-Maximilians-University of MunichLindwurmstr. 2aMunichD-80337Germany

En prensa. Pruebas corregidas por el autor. Disponible en línea desde el Sunday 11 July 2021
This article has been published in an issue click here to access

Abstract

Introduction

The fixation of condylar neck fractures is raising difficulties and for this reason, many plate designs have been developed. The current study compares the performance of four miniplates used in the condylar neck.

Material and Methods

A virtual condylar neck fracture in a mandible obtained from a CT scan was fixed with four miniplates (two straight miniplates, lambda, strut, and trapezoidal). Using finite element analysis, we examined the fragments' displacements and stress distribution in the titanium material and bone. The models were analyzed under two loading conditions: a reduced bite force of 135 N and a force of 500 N.

Results

No risk of material failure was observed. For a load of 135 N, all four plates offer an adequate fixation. For 500 N of applied loading, the lambda and strut plates showed the best rigidity and lowest bone strains. The two parallel plates showed the lowest rigidity and the trapezoidal plate the highest bone strains around all screws.

Discussion

These findings imply that three-dimensional miniplates (lambda, strut) perform better when higher loads are applied. On the other hand, the trapezoidal plate has an increased risk of screw loosening and the two straight plates higher mobility of the fragments.

El texto completo de este artículo está disponible en PDF.

Keywords : Finite, Osteosynthesis, Condylar, Neck, Strut, Lambda