A satisfactory treatment of an 18-year-old lady was reported with right combination-type condylar hyperplasia (CH) in active phase. The chin severely deviated to the left, with the right gonial angle locating at a lower level. Intraorally, the lower centre line shifted to the left, the scale of which reached the width of one lower incisor. The right molar relation was mesial. Right maxillary second molar over-erupted without contact to lower teeth. There had been 2.5-mm anterior open bite (AOB) before surgery (T1) due to the tongue-spitting habit. After judging the benefits and disadvantages of all treatment alternatives, the decision was made to perform a right condylectomy and post-surgery orthodontics. Before orthodontics (T2) when the chin was positioned centred, an asymmetrical open bite occurred, caused by pre-contact between the right maxillary and mandibular second molars. Meanwhile, the AOB at T2 became 11.5mm. Orthodontic-related treatment included four premolars extraction and intrusion of bilateral maxillary molars using four miniscrews. Finally, this treatment achieved a clinically centred chin with two gonial angles at the same level. Post-condylectomy, the large AOB was resolved, together with a bilateral neutral molar relationship and alignment of the incisor midlines. Besides, the resected right condyle was covered by a continuous cortex bone and returned to the glenoid fossa. In sum, a high-challenging combined-type CH case was accomplished with impressive improvement in facial and occlusal symmetry, thanks to condylectomy and post-surgery miniscrew-assisted orthodontics.