Transverse, vertical, and anterior-posterior changes between tooth-anchored versus Dresden bone-anchored rapid maxillary expansion 6 months post-expansion: A CBCT randomized controlled clinical trial - 11/05/20
pages | 9 |
Iconographies | 1 |
Vidéos | 0 |
Autres | 0 |
Summary |
Objective |
The main aim of this randomized clinical trial was to determine 3 dimensional skeletal and dental changes six months after the use of bone-anchored versus tooth-anchored rapid maxillary expanders in adolescents. The secondary aim was to determine the symmetrical or asymmetrical expansion pattern between both appliances.
Materials and methods |
Fifty adolescents with skeletally constricted maxilla (mean age 13–14 years) were randomly assigned into: Dresden B-RME, Hyrax T-RME, or untreated control groups. CBCT scans were taken at initial and expander removal (6 months). Three-dimensional references and treatment landmarks were identified. Orthogonal distances were calculated from those landmarks. The main outcome was to compare skeletal and dental changes in each group and the secondary outcome was to verify if these changes were symmetric or not. Data was analysed using descriptive statistics and repeated measure MANCOVA and MANOVA.
Results |
Both treatment groups showed significant skeletal and dental expansion compared to controls. T-RME group had greater mean inter-molar crown expansion (5.66mm) than the B-RME group (4.17mm). Both T-RME and B-RME groups showed significant skeletal maxillary expansion compared to controls (mean 1.27mm and 1.31mm respectively, both p<0.01), although no significant difference was found between both appliances. B-RME group showed a lower ratio of dental to skeletal expansion than T-RME group. T-RME showed a symmetrical expansion pattern, whereas the B-RME showed an asymmetrical pattern relative to mid-sagittal plane. The extent of molar crown expansion was 1.84mm greater on the TAD-side compared to the Implant-side. T-RME group showed significant anterior movement of the maxillary first premolar and molar (1.5mm, p<0.05), and vertical dental extrusion (1.8mm). No significant dental vertical or anterior-posterior changes were noted in the B-RME group.
Conclusions |
T-RME and B-RME produced similar amounts of skeletal expansion. B-RME group produced a lower component of dental expansion. Due to the Dresden B-RME configuration, asymmetrical expansion was noted.
Le texte complet de cet article est disponible en PDF.Keywords : Rapid maxillary expansion, Bone-borne expander, Tooth-borne expander, Cone-beam computed tomography
Plan
Vol 18 - N° 2
P. 308-316 - juin 2020 Retour au numéroBienvenue sur EM-consulte, la référence des professionnels de santé.
L’accès au texte intégral de cet article nécessite un abonnement.
Bienvenue sur EM-consulte, la référence des professionnels de santé.
L’achat d’article à l’unité est indisponible à l’heure actuelle.
Déjà abonné à cette revue ?